Description

CARBON REMOVER is a strong liquid product suitable for removing carbon deposits from ferrous and non ferrous metals. Also removes mineral oils, residual combustion products, grease, etc.

Usage

CARBON REMOVER is used for cleaning :

• Burner tips
• Heavy fuel heaters
• Filters for lubricants or fuel oils
• Heat exchange units in oil refineries
• Oil coolers
• Diesel engine injectors
• Machine parts :
  • pistons
  • piston rings
  • valve springs
  • connecting rods
  • carburetors etc.

Application

CARBON REMOVER is applied cold by dipping, or brush, neat . The product can also be applied by spraying, providing that all the necessary precautions should be taken (e.g. goggles, gloves, etc.).

The product can also be used diluted with petroleum distillates or water, but its efficiency will be reduced.

Allow parts to be in contact with solution for 15 minutes minimum and then rinse with water under pressure.

For tenacious carbon deposits the contact time may be longer (e.g. over night) without any effect to the metal.

NOTE : When CARBON REMOVER is used in tank (dipping method), it is necessary to remove periodically the soils from the bottom of the tank.

Description

S – 2055 is a strong aircraft paint stripper tank – type in liquid form with two – layers which meets the requirements of MIL – R – 83936 A Type I, class II and Type II, class II and BOEING DOCUMENTS D6 – 17 487.

Application

S- 2055 is applied mainly for removing paint coatings from the landing gear wheels of aircraft. It is excellent for the removal of the most types of paint coatings such as polyurethane, epoxies, nitrocelluloses etc. S – 2055 except paint, removes also carbon deposit oils, greases etc.

Usage

S- 2055 is used only cold and by immersion. The parts to be stripped must be totally immersed in the lower layer. Most paint schemes will be removed fairly readily but the very resistant types may require several hours soaking. After soaking parts must be rinsed with water under pressure.

Products properties

Appearance: Liquid with two – layers pH (low layer): > 10

Compatibility: Doesn’t corrode metals.

May swell rubbers.

General information

Mild steel or stainless steel are recommended for tank construction. The upper layer is an aqueous solution containing anti – corrosion agents, special additives etc. The aqueous solution of upper layer prevents the evaporation of the lower layer which is the drastic one. Add water in order to minimize the drag – out loss of the upper layer.