Description
KEM-041 is an acidic, liquid product used for continuous or during shutdown removal of alum, fillers, color, titanium clay and other foreign substances from felts, cylinders, vats, cylinder molds, screens, suction press rolls and other comparable pieces of paper mill equipment.
Advantages
- Suitable for removing various soils.
- Cleans felts and equipment.
- Cost efficient, low usage cost.
- Simple to use, dissolves instantaneously in water.
Directions
Felt cleaning: Use a 4% solution of KEM-041 in water at a temperature of 100ºF. Allow the solution to penetrate the felt for approximately 25 minutes and then rinse with water for approximately 20 minutes.
Screens: Use a 10% solution of KEM-041 in water at a temperature of 160-180ºF. A sufficient amount of KEM-041 is pumped into the bottom of the screen. Rotate mechanically for approximately 30 minutes then flush with water.
Cylinder Vats, Cylinder Faces: Use a 10% solution of KEM-041 in water at a temperature of 160-180ºF. Raise felts, pump solution onto cylinder faces through cylinder showers and allow solution to barely cover the bottom of the cylinder. Rotate for 15-20 minutes and rinse thoroughly.
Suction Press Rolls: Use a 10% solution of KEM-041 in water at a temperature of 160ºF. Pump solution into saveall to a point of approximately 2½” above the bottom of the suction roll. Rotate until clean and then rinse.
Continuous Felt or Wire Cleaning: Apply KEM-041 through a low volume shower or conditioning equipment and inject 100-400 ppm through a proportioning pump.
| 
(SDS)